Normal Operation - EINHELL SPK7 Originalbetriebsanleitung

6. Normal Operation

6.1 Power On/Off
Press Button „ " for 2 seconds then the display will power on, and the controller will power on at the
M
same time. With display on, Press Button „
the display off, the display and controller shut down. The leakage current of display on shutdown state is
less than 1μA. When the e-bike is without using for 10 minutes, the display will shut down itself automa-
tically.
6.2 Speed Display (Real-time speed/Average speed/ Max speed)
After starting up the display, default show is real-time speed. Long press both „
2s to change the indicated information in sequence as below:
Real-time Speed (Km/h) → Average Speed (Km/h) → Max Speed (Km/h).
6.3 Distance Display (Trip Distance/ Total Distance)
After starting up the display, default show is Real-time speed. Press button „
information in sequence as below: Trip Distance (km) →Total Distance (km). Long press the two buttons
„ " and „-" , the trip distance will be reset to zero.
M
6.4 Turn on/off Backlight
Press button „+" for 2 seconds to turn on the backlight of the display, the headlight will be on at the same
time. Hold Button „+" for 2 seconds again, backlight is off.
Anl_Tacho_SPK7.indb 13
" for 2 seconds to turn off power system of the e-bike. With
M
Trip Distance (TRIP)
Turn on Backlight
GB
→ Total Distance (ODO)
- 13 -
" and „+" buttons for
M
" to change the indicated
M
24.08.2018 12:18:15