HANSGROHE 96660000 Montageanleitung Seite 4

English
Plaster in the installed and checked ibox, in case
of pre-wall installation cover the ibox with a
panel.
After the plastered wall surface is dry seal the gap
between wall and plastic housing of the ibox.
Apply PCI-Lastogum or similar sealing compound
on the wall in accordance with manufacturers
indications.
Put gasket over the plastic housing of the ibox.
Attention: The gasket is not suitable for hot glue. If
the ibox universal should be hot glued, please
take care that the mixer is not damaged.