Cleaning And Maintenance - Perel PTC0002 Bedienungsanleitung

5. Overview
Refer to the illustrations on page 2 of this manual.
1
2
6. Installation
The heater shall be used as a portable appliance only. Install vertically on a flat, dry,
stable and non-slippery surface.
7. Operation
Insert the power plug into the mains.
Turn the thermostat knob fully to the right.
Switch on the heater by selecting the power (I = 750 W/II = 750 W/I+II = 1500 W).
When the room has reached the desired temperature, turn the thermostat knob to the
left until the heater switches off. The temperature is now set and the heater will
automatically switch on/off to keep the temperature at a constant level.
Switch off and disconnect the heater after use.
This appliance is equipped with a tilting protection, which automatically switches off the
heater when it is pushed over. To restore the heater, re-install in the proper vertical
position.
8.

Cleaning and Maintenance

Before cleaning, switch of the appliance, disconnect from the mains and allow to cool
completely.
Never immerse the appliance in water or any other liquid. Protect it from splashes and
spraying liquid.
Occasionally wipe with a damp cloth to keep it looking new. Do not use harsh chemicals,
cleaning solvents or strong detergents.
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.perel.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 02 – 15/06/2018
heat setting button I
thermostat knob
PTC0002
3
6
heat setting button II
©Velleman nv