Maestro MR400 Bedienungsanleitung Seite 7

- connect the plug to the socket and switch on the machine by
positioning the switch to position «I»-ON. The indicator will light up
and the machine will start operating.
- After there remains no water in the teapot, switch off the machine
with the switch by placing it in position «0»- OFF. The indicator will
go out and the device will be disconnected. The heating of water
can be stopped at any moment by pressing the switch.
Let it cool for 5 minutes, pour out the water from the container.
Repeat the above mentioned procedure for 1-2 times.
Making coffee
The process of coffee making consists of passing hot drops of water
and vapor particles through ground coffee. This technology ensures
making tasty and fragrant drink without excessive boiling which
makes the drink too bitter.
It is recommended to use well roasted and freshly ground coffee
and cold water for making coffee.
To make coffee:
- pour the required quantity of ground coffee on the filter without
tramping down. It is enough to put about 6-7 g of coffee for a 100
ml cup.
- place the filter in the brew basket's case;
- fill the container with water to the necessary level, approximately
100 ml for a cup of drink;
- close the cover of the container;
- switch the machine as described earlier, the machine will start the
operation and the drink will begin collecting in the cups after a little
while.
When the coffee is ready, switch off the machine with the switch.
If you want to have your coffee hot for some time, you can leave
the carafe with drink on the heater plate and switch on/off the coffee
7