ABB ODINsingle Installationsanleitung Seite 17

Protection Class
Installation requirements
To comply with the protection requirements the
meter must be mounted in protection class IP 51
enclosure or better, according to IEC 60529.
Test and Verification
The ODINsingle meter has a red LED in the
middle of the front (see No. 10 in fig 1) that flas-
hes in proportion to the active energy that can be
used when testing and verifying the meter. This
LED has a fixed pulse frequency which is marked
on the front of the meter.
Cleaning
If the meter is dirty and needs to be cleaned,
use lightly moistened tissue with a water based
mild detergent. Make sure no liquid goes into the
meter as this could damage the meter.
15
2CMC482010M0002