Black Mark Paper - Seca 465 Bedienungsanleitung Und Garantieerklärung

Adjust sensors for
labels and Black Mark
Black Mark paper sensor
Label detection photocell
Label detection LED
The seca 466 printer has separate sensors for labels
or Black Mark paper to control the paper feed and
paper cutter.
paper
NOTE
The printer is preset to the labels available from
seca. You need only carry out the procedure
described here if you want to use different
labels or Black Mark paper.
You must set the sensor to suit the type of paper in
use.
Cover for paper type
sensors
1. Ensure that the device is switched off.
2. Open the paper compartment cover.
3. Switch the device on.
4. Keep the Feed key depressed and close the paper
compartment cover.
The Error LED flashes.
5. Open the paper compartment cover.
6. Insert the desired paper (see "Insert paper roll" on
page 54).
– Insert labels so that with the paper
– Insert Black Mark paper so that the black
7. Close the paper compartment cover.
8. Open the cover for the paper type sensors.
Adjusting wheel for Black Mark paper sensor
LED for paper type
sensors
compartment cover closed, a label is
positioned between the Label detection
LED and the Label detection photocell.
mark of the paper does not cover the
Black Mark paper sensor with the paper
compartment cover closed.
Before you get started ... • 55
English
Adjusting wheel for
label sensor