Mode Setting - Tiiwee TWPIR01 Bedienungsanleitung

The Tiiwee PIR sensor is equipped with some additional features to allow you to adjust the device to
your specific needs. Remove the back panel and the batteries for access to these settings. In the
battery compartment, there are 3 switches and one tamper sensor to adjust the settings of your PIR
sensor.
1. In armed mode the Anti-tamper switch automatically triggers the alarm if the back panel is
removed. This means that the unit cannot be deactivated through the On/Off switch without
triggering an alarm.
2. An On/Off Switch can be used to permanently inactivate the PIR sensor
3. The Indicator light can be switched off to save battery power ("LED OFF position). Off course,
in this mode an alarm signal will still be sent to the Alarm Unit or the PIR Motion Sensor
Alarm. However, please note that the low battery indication (LED flashing every 3 seconds)
is switched off in this setting.
4. A waiting time of 5 minutes between detections can be set saving battery power ("5 Min" vs
"5s" switch). The 5-minute waiting period can be used when your PIR sensor is meant to
result in a strong Siren alarm. This mode however is not advised when you selected a Chime
sound setting on your Alarm unit.
Low-voltage Reminder Function: When the voltage of the PIR is lower than 2.4V, the indicator light
will flash once every 3 seconds unless its lights have been switched off by setting the internal
switches.
Anti-tamper Function: The PIR sensor is equipped with an anti-tamper switch. When someone tries to
remove the back plate from the detector (to remove the batteries and disable the PIR sensor) a signal
will be sent to the Alarm unit.

Mode Setting

The factory settings are "5s" and "Led On". This means that the sensor will respect a 5-seconds waiting
time between 2 signals and that the LED indicator light will always flash if movement is detected. These
are the most commonly used settings.
1. If both switches are set to the ON position as shown in picture 1, the LED will flash each time a
movement is detected. After each signal, a 5 second waiting time is set as a standard to allow a
person to pass without triggering a signal continuously.
2. If the top switch is set to Off the detector will respect a 5-minute delay before it will become
active again. This is a power saving mode. This setting can perfectly be used with a loud alarm
(which will sound continuously and loud). A Chime setting on the Alarm unit is not advised with