AB Quality Series B Installationsanleitung Seite 8

8 SLC 500™ Modular Chassis
3
ATTENTION
! ! ! !
Slide the chassis over the installed hardware and tighten the screws.
4
Leaving far-left and far-right tabs open for grounding, install the remaining
tab hardware (for a four-slot chassis, leave both tabs open).
Publication 1746-IN016A-MU-P
If the chassis mounting tabs do not lay flat before the
screws are tightened, use additional washers as shims so
that the chassis will not be warped by tightening the
screws. Warping a chassis could damage the backplane
and cause poor connections.