Sensors; Electroblockebl; Initial Use; Checkspriortoinitialuse - Schaudt LT 45X Series Montageanleitung

4.2
4.3
5.1
Prior to use
5.2
230V mains operation
9310330 MA /EN
Installation Instructions Operator and control panel LT 45X

Sensors

Connect the tank sensors for two different tanks:
"
5-pinconnector: Waste water tank
F
6-pinconnector: Water tank
F
EBL... electroblock /CSV... caravan power supply
Plug the ready-made cable (13-pin)into the LT 45X control panel.
"
Plug the other end of the ready-made cable into the power supply unit
"
(EBL ... or CSV ...):
To identify the plug connector and for information on the pin plug-inas-
Y
signment, refer to the operating instructions for the associated power
supply(EBL ... /CSV ...)
5

Initial use

Checks prior to initial use
Ensure the leisure area battery is connected (and the starter battery as
"
required).
Ensure that an electroblock or caravan power supply is connected (also
"
refer to the instruction manual and installation instructions for that elec-
troblock or power supply).
Disable shutdown on the relevant power supply unit; to do this,
"
enable the battery cut-offswitch of the relevant power supply
"
or
attach the battery terminals
"
Also refer to the operatingmanual for the relevant power supply (EBL ... ,
Y
CSV ...)
Ensure that the accessory for measuring the filllevel of the water tank is
"
connected and operational.
Switching on and off the 12V supply for the leisure area
Connect the input to the mains supply of the vehicle to the 230V mains
"
supply.
Mains indicator LED lights up. The leisure area battery is being charged. For
details on the charge functions, refer to the operating instructions for the re-
levant power supply(EBL ... /CSV ...).
The 12V supply of the vehicle is switched on from the relevant button. The
refrigerator controller is an exception. It also works when the 12V power
supply is switched off --referto the operating instructions for the relevant
power supply(EBL ... /CSV ...).
Date: 12.07.2018
5