Niko 10-490-03 Handbuch Seite 24

10-490-03 10-490-03
4. SETTINGS
4.1. Directing the camera
1. Loosen the adjustment screw for orientation with the hexagonal key supplied.
2. Point the camera in the right direction and lift the camera cap up.
3. Tighten the adjustment screw again.
4. Check whether all adjustment screws and camera cap are properly tightened.
4.2. Setting the camera
4.2.1. Choose the image section
1. Remove the camera cap.
2. Remove the socket anchor.
3. Loosen the adjustment screw for zoom adjustment with a small screwdriver.
4. Adjust the image section by turning the adjusting wheel.
5. Check the image section with an internal unit that you connect to the installation.
6. Follow the zoom setting with the internal unit until you have obtained the desired image section.
7. When the size of the image section is not satisfactory, choose another position for the camera.
4.2.2. Adjusting the focus
1. Loosen the adjustment screw for focus adjustment with a small screwdriver.
2. Turn the adjustment wheel until the image on the internal unit is sharp.
Tip: Install the camera preferably at twilight so that the aperture opens maximally and good field depth is reached.
4.2.3. Tightening
Tighten the adjustment screws for zoom adjustment and focus adjustment after setting in order to save the settings.
24 ENG