Niko 10-490-03 Handbuch Seite 23

10-490-03 10-490-03
3. MOUNTING
Danger: Disconnect all power before installing the surface-mounting camera. Do not connect the device to the mains voltage until installation is complete.
Tip: For optimal image quality and a long service life, please observe the following installation tips:
Do not point the camera lens at the sun.
•
Do not install the camera behind glass.
•
Do not install the camera near a water drainage area to prevent water seeping into the camera.
•
Connect the cables as shown in the wiring diagram below.
➀
Joystick
➁
Connection for a monitor
➂
Adjustment screw for zoom adjustment
➃
Adjustment screw for focus adjustment
➄
Adjusting wheel for zoom adjustment
➅
Adjusting wheel for focus adjustment
23
➃
➂
➄
➅
➀
➁
ENG