Herunterladen Diese Seite drucken

Werbung

EN Instructions for use / assembly instructions
DE Gebrauchsanleitung / Montageanleitung
2
3
Cento XL 2jet
14803003
Focus M41 240 2jet
31815XX3 / 31815019

Werbung

loading

Inhaltszusammenfassung für HANSGROHE Focus M41 240 2jet 31815019

  • Seite 1 EN Instructions for use / assembly instructions DE Gebrauchsanleitung / Montageanleitung Cento XL 2jet 14803003 Focus M41 240 2jet 31815XX3 / 31815019...
  • Seite 2: Safety Notes

    English Operation (see page 10) Safety Notes UngarischTausch Gloves should be worn during installation to prevent • Hansgrohe recommends not to use as drinking water crushing and cutting injuries. the first half liter of water drawn in the morning or The hot and cold supplies must be of equal after a prolonged period of non-use. pressures. • Do not rotate the spout further than 360º or damage Installation Instructions to the hose will result. • Prior to installation, inspect the product for transport Maintenance (see page 7) damages. After it has been installed, no transport or surface damage will be honoured. The check valves must be checked regularly according • The pipes and the fixture must be installed, flushed to DIN EN 1717 in accordance with national or and tested as per the applicable standards. regional regulations (at least once a year). • The plumbing codes applicable in the respective Test certificate (see page 16) countries must be observed. Technical Data Operating pressure: max. 1 MPa Recommended operating pressure: 0,1 - 0,5 MPa Test pressure: 1,6 MPa...
  • Seite 3: Sicherheitshinweise

    Serviceteile (siehe Seite 14) Sicherheitshinweise XX = Farbcodierung Bei der Montage müssen zur Vermeidung von 00 = Chrom Quetsch- und Schnittverletzungen Handschuhe 80 = Stainless Steel Optic getragen werden. Reinigung (siehe Seite 12) Große Druckunterschiede zwischen den Kalt- und Warmwasseranschlüssen müssen ausgeglichen Bedienung (siehe Seite 10) werden. UngarischTausch Montagehinweise • Hansgrohe empfiehlt, morgens oder nach längeren • Vor der Montage muss das Produkt auf Stagnationszeiten den ersten halben Liter nicht als Transportschäden untersucht werden. Nach dem Trinkwasser zu verwenden. Einbau werden keine Transport- oder • Auslauf nicht weiter drehen als 360º, da sonst der Oberflächenschäden anerkannt. Schlauch beschädigt werden kann. • Die Leitungen und die Armatur müssen nach den gültigen Normen montiert, gespült und geprüft Wartung (siehe Seite 7) werden. Rückflussverhinderer müssen gemäß DIN EN 1717 • Die in den Ländern jeweils gültigen regelmäßig in Übereinstimmung mit nationalen oder...
  • Seite 4 (3 Nm) CLICK SW 24 mm SW 10 mm (4 Nm)
  • Seite 5 > 2 min (1 Nm)
  • Seite 6 60 °C 10 °C 0,3 MPa 36°C 38°C 50°C 60°C 43°C 55°C 17 x...
  • Seite 7 31815XX3 31815019 14803003...
  • Seite 8 Focus M41 240 2jet 31815XX3 / 31815019 Ø Ø Ø 34 G 1/2 G 1/2 Focus M41 240 2jet Focus M41 240 2jet 31815XX3 31815019 0,50 0,45 0,40 0,35 0,30 0,25 0,20 0,15 0,10 0,05 0,00 9 12 15 18 21 24 27 30 Q = l/min Q = l/sec...
  • Seite 9 Cento XL 2jet 14803003 2 3 5 Ø 15 3 2 2 0 10 8 Ø Ø G 1 / 2 G 1 / 2 Cento XL 2jet 14803003...
  • Seite 10 31815XX3 / 31815019 / 14803003 open / öffnen open / öffnen close / schließen hot / warm cold / kalt...
  • Seite 11 31815XX3 / 31815019...
  • Seite 12 Cleaning recommendation / Warranty / Contact einigungsempfehlung / Garantie / Kontakt www.hansgrohe.com/ cleaning-recommendation www.hansgrohe.com/ cleaning-recommendation www.hansgrohe.com/ cleaning-recommendation www.hansgrohe.com/ cleaning-recommendation...
  • Seite 13 97735000...
  • Seite 14 Focus M41 240 2jet 31815XX3 98193000 98356XX0 (32x2) 95562XX0 96338000 95498XX0 98127000 (11x2) 97209000 97735000 (M37x1,5) 92730000 SW 30 mm 95332000 98231000 (18x1,5) 95140000 (M4x20) 98459XX3 SW 4 mm 95008000 98140000 98212000 (20x1) (41x2) 97489000 95910000 (900 mm) 95909000 SW 24 mm Focus M41 240 2jet 31815019 95376000 97523000 95561000...
  • Seite 15 Cento XL 2jet 14803003 95562000 97209000 (M37x1,5) 92204000 SW 30 mm 98127000 96338000 (11x2) 95498000 98193000 (32x2) 92730000 97735000 95332000 98231000 95140000 (18x1,5) (M4x20) SW 4 mm 98459000 95008000 92482000 (600 mm) SW 24 mm 98140000 (20x1) 95909000 95910000 97523000 95561000 (600 mm) 95049000 95507000 (1500 mm) 98551000...
  • Seite 16 Hansgrohe · Auestraße 5 - 9 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440 E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com...

Diese Anleitung auch für:

Cento xl 2jet 14803003