The turn indicators do not work
The alarm is not triggered when
the ignition is switched on
The alarm fuse blows every
time the system is armed
The alarm/immobiliser is
disarmed, but the motorcycle
will not not start
(6828-9)
The system is not triggered by
moving/lifting the bike
SPYBALL 6808-9/6828-9 ENGLISH
-
Is the diode installed the wrong
way round?
Make sure that there is a 12V
-
positive supply when the ignition
is switched on to the ORANGE/n.
2 wire
Try a substitute unit. If the
-
problem remains it is either an
installation problem or a problem
with the motorcycle
Has the diode been installed?
-
-
Check the earth connections
Try a substitute unit. If the
-
problem remains it is either an
installation problem or a problem
with the motorcycle
-
Is the motorcycle in neutral gear?
Is the kill switch in the RUN
-
position?
Make sure that the main ignition
-
fuse in the motorcycle is intact
Make sure that the motorcycle
-
battery is charged
Some models will only start with
-
the side stand up or the clutch
lever pulled in
-
Try a substitute unit. If the
problem remains it is either an
installation problem or a problem
with the motorcycle
-
Has the arming time elapsed?
Is the movement sensor active
-
(not disabled)?
Adjust the movement sensor (see
-
paragraph 4)
20