Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sun G10
2.4 Nozzle and electrodes
Choosing the nozzle
Determine the required fuel flow-rate, based on the heat
input of the boiler and the minimum heat output (Hi) of
the fuel used (see table of technical specifications, Chap.
4). Based on the flow-rate calculated, use the table
below, according to the pump pressure, to determine
the most suitable nozzle size (in GPH). The bold values in
the table are the most suitable for the operation of the
burner. In the case of burners with preheater, the effective
flow-rate value is lower by around 10% than the values
shown in table.
Table of oil nozzle flow-rates
The values shown below are purely indicative, as
it should be remembered that the flow-rates of
the nozzles may change by ± 5%.
Table of spray values
The nozzles are available with different sprays, identified by one or more letters, depending on the
manufacturer. The table shows the most suitable types of spray for the burner.
SPRAY
Assembling the nozzle
Once the correct nozzle has been selected, proceed as follows for the assembly:
E
C
A
B
Angle
Type of cone
Delavan
60°
Full
E
Nozzle G.P.H.
0,40
0,50
0,60
0,65
0,75
0,85
1,00
1,10
1,20
1,25
1,35
1,50
1,65
1,75
2,00
2,25
2,50
3,00
Type of nozzle
Monarch
Danfoss
S
B
AR
F
G
fig. 5
Pump pressure (bar)
9
10
11
12
13
1,44
1,52
1,59
1,67
1,73
1,80
1 ,90
1,99
2,08
2,17
2,16
2,28
2,39
2,50
2,60
2,34
2,47
2,59
2,71
2,82
2,70
2,85
2,99
3,12
3,25
3,06
3,23
3,39
3,54
3,68
3,61
3,80
3,99
4,16
4,33
3,97
4,18
4,38
4,58
4,77
4,33
4,56
4,78
5,00
5,20
4,50
4,75
5,00
5,20
5,40
4,87
5,13
5,38
5,62
5,85
5,41
5,70
5,90
6,24
6,50
5,95
6,27
6,58
6,87
7,15
6,31
6,65
6,98
7,29
7,58
7,21
7,60
7,97
8,33
8,67
8,15
8,55
8,97
9,37
9,75
9,01
9,50
9,97
10,41
10,83
10,82
11,40
11,96
12,49
13,00
Flow-rate at the outlet in kg/h
Steinen
Hago
Fluidics
S - SS
ES
SF - S
B
7
14
1,80
2,25
2,70
2,92
3,37
3,82
4,50
4,95
5,40
5,60
6,07
6,75
7,42
7,87
8,99
10,12
11,24
13,49
21
Werbung
Inhaltsverzeichnis
