profi-pumpe OASIS 200-3 Li+LED Bedienungsanleitung Seite 4

6 English
l When the battery is worn out, wrap the terminals with adhesive tape or similar materials be-
fore disposal
l Immediately discontinue use of the battery, if there is an unusuak smell, a change of color or
shape, or if it appears abnormal in any other way
l Do not place the battery in microwave ovens, high pressure containers or on cookware facili-
ties
l In the event of the battery is leaking and fluid gets into your eye, do not rub the eye, rinse
well with water and immediately seek medical advice. If left untreated, the battery fluid could
cause serious injury to the eye
9. ServicinG
If after some time the pump starts losing power or stops working, please clean up sediment in
the pump shell or filter cribs. Please note the pump can be opened by pressing down on the bot-
tom of the filter housing.
To clear the impeller, open the pump housing at the front by sliding up the front plastic cover.
the solar module should only be cleaned with soft tissue or propriety glass cleaning
solution.
9.1. the following controls should be carried out regularly:
l Cleanness of the medium (no mud).
l Moreover, the pump should be emptied by danger of frost, has to be washed out with clear
water and stored dry.
10. recoGniSinG and repairinG of miStakeS
problem possible cause
No sunlight
Low battery power
Connector from the pump is
Pump will not
not connected correctly
turn on
Defective pump / solar panel
broken
Pump impeller and filter hou-
sing polluted
Pump runs but
no water is en-
The flow regulator on the
couraged
pump is closed
Coarsining or fountain noz-
zles dirty
Pump has drawn in air
(Avoid Caution! Dry running)
No proper water Fountains nozzles and tubes
fountain are dirty
Solution
The orientation of the solar panels up to the sun
See point 7. (Battery information)
See point 3.
Replace pump or solar panel. For fault isolation:
solar panel Check if the specified voltage is pro-
vided. Operate the pump to an external battery.
Disassemble and clean in accordance with
point 5, the pump and the housing (by means
of water and a soft brush)
Open the flow regulator on the pump.
Disassemble and clean the tube and the
fountain nozzle
Stop the pump briefly and then back on.
(Restarting)
Clean the fountain nozzles or tubes
11. Security tipS
l Obey absolutely valid regulations on the electrical security
l Never run pump dry
l Pumping inflammable, as well as all other aggressive liquids is prohibited
l Pay attention to the medium temperature max. 35°C
l Never pull the pump on the electrical cable or pressure hose
l Avoid cross section narrowing
l Pay attention to the given particle size
l During longer unused times, clean the pump, wash it out with clear water, dry and store
it at room temperature
l Test wells for enough flowing water (dry run danger)
l The pump may be used by children aged 8 years and above as well as persons with
reduced physical, sensory or mental abilities or those who lack skills, experience and
knowledge only if they are supervised. These aforementioned persons should only use
the appliance while adhering to safe instructions and resulting dangers.
l Cleaning and maintenance must not be carried out by children without supervision.
the manufacturer explainS:
l To take over no responsibility in the case of accidents or damages on the basis of careless-
ness or disregard to the instructions in this manual.
l To reject every responsibility for the damages which originate from the improper use of the
device.
12. Guarantee reGulationS
For all manufacturing and material defects, the statutory warranty applies. In these cases we
take the replacement or repair of the device. Shipping costs shall be borne by our company,
except as required by law. Please report the warranty on our service platform http://www.profi-
pumpe.de/service.php. We will inform you how to proceed with case-related. Returns please
sufficient postage. Unfortunately not prepaid returns can not be accepted because they are
filtered out before delivery. Our service we provide in Germany.
The warranty does not cover:
l Material wear (sealing rings, impeller wheels, impeller chambers)
l Unjustified interventions or changes in the pump
l Damages by selffault
l Improper servicing and improper use
l DRY RUNNIG (Also partially!) of the pump
moreover, we give no damage compensation for secondary damages!
English 7