Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
Operation
The Splitter Extender uses preset EDID values as defined in the table below, allowing you to configure
the Extender to work correctly with the capabilities of your HDMI equipment. In total there are 9 presets
using different resolution, scan and audio values for you to choose from, alternatively you may use the
EDID of the display connected to the HDMI Out port of the Transmitter unit. Each time a change is made
to the EDID setting the Transmitter must be power cycled, in some cases it may also be necessary to
power cycle the source device too. (Black squares denote the location of the dip switch).
Position
1080p, 2 Channel Audio
1080p, Dolby/DTS 5.1
Channels
1080p, HD Audio
1080i, 2 Channel Audio
1080i, Dolby/DTS 5.1
Channels
Troubleshooting
There is no display on the screen.
▪
Check that the DC plug and jack used by external power supply is firmly connected and that the
Power LED on both the Transmitter and Receivers are illuminated.
▪
Check that the Cat.6 cables are seated correctly and that the Lock LED on is illuminated on all
Receivers.
▪
Power off all the devices, then power on in this order: first, the Transmitter unit, followed by the
display(s) and finally the source.
▪
For some HDMI devices it may be helpful to unplug and replug their HDMI connection to re-initiate
the HDMI handshake and recognition.
▪
Check that the EQ setting matches the Cat.6 cable length being used. If the primary EQ setting does
not work, please try the secondary setting for the length of Cat.6 cable being used.
▪
Reduce the length of Cat.6 or HDMI cable used, or use a higher quality cable.
EDID Description
Position
EDID Description
1080i, HD Audio
3D, 1080p, 2 Channel
Audio
3D, 1080p, Dolby/DTS 5.1
Channels
3D, 1080p, HD Audio
Copy from the display
connected to HDMI OUT
English
Werbung
