Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
IR Receiver
Installation
Important! If you want to lay cables inside a cable duct or through a wall, please test your Cat.6 cables in
a test installation at the highest desired resolution/colour space/colour depth combination with the
extender BEFORE you install them in your wall or cable duct!
The following steps are for an installation using HDMI equipment, if you are using DVI equipment, please
substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the Transmitter unit using a HDMI cable (maximum length 3m).
2. Connect one end of the Cat.6 cable (max. length 50m) to the CAT OUT 1-4 ports on the Transmitter
and the other end to a CAT port on each of the Receivers. We strongly recommend the use of solid
core Cat.6 installation cable.
3. Set the EQ on each of the Receivers to the setting which matches the Cat.6 cable length (see table
below), either the Primary or Secondary may be used depending on picture and cable quality (Black
squares denote the location of the dip switch).
Cable
Length
Under 15m
(49.5ft)
15 – 30m
(49.5 – 99ft)
4. Use another HDMI cable (maximum length 3m) to connect an HDMI display device to the HDMI
output port on each Receiver unit.
5. An additional HDMI display can be connected to the HDMI Out port of the Transmitter if required for
local monitoring or cascading to an additional Transmitter.
6. Set the EDID Switch according to your requirement, see the EDID table in the operation section of
this manual.
7. For additional Infrared remote signal functionality, connect the included IR Extension Cables to the
Transmitter and Receiver units, using the IR Emitter with the IR Out port on the Transmitter and the
IR Receiver with the IR In port of the Receivers.
8. Place the IR Emitter in front of the IR Port of the equipment you want to control, and ensure you
place the IR Receivers in a location where they may easily receive the signal of your IR remote.
9. Power on your HDMI Source and Display to complete the installation.
10. Finally plug the DC power supply into the Transmitter unit and set the Power Switch to On, the
Power LED will illuminate on all units.
Primary
Secondary
Setting
Setting
IR Emitter
Cable
Length
30 – 40m
(99 – 132ft)
40 – 50m
(132 – 164ft)
Primary
Secondary
Setting
Setting
English
Werbung
