Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
▪
Supports 20 – 60kHz IR Frequencies
▪
Features 9 EDID presets, plus EDID learning from the local HDMI output
▪
Adjustable EQ to match Cat.6 cable length
▪
Transmitter ports: HDMI Type A In and Out, 4x CAT6 Out, 3.5mm IR Out & DC Socket
▪
Receiver ports: HDMI Type A Out, 1x CAT6 In & 3.5mm IR In
▪
Power consumption: 8W Max
▪
ESD Protection: ± 8kV (air-gap discharge)
▪
Human Body Model: ± 4kV (contact discharge)
▪
Operating temp: approx. 0 to 40°C / Storage temp: approx. -20 to 60°C
▪
Relative Humidity: 20-90% RH (non-condensing)
▪
Product Dimensions: Transmitter 210x83x17mm / Receivers 79x68x17mm (each)
Overview
Transmitter
1. Power LED: Illuminates when the Transmitter is connected to the power supply and switched on.
2. CAT OUT 1-4: Connect to Cat.6 cables to make the connection to the Receiver units.
3. HDMI OUT: Connect to a local HDMI display or to another Transmitter unit to cascade to more
remote displays.
4. HDMI IN: Connect to your HDMI source device using a good quality HDMI cable.
5. IR OUT: Connect the supplied IR Emitter.
6. EDID: Dip switches to select which EDID is used.
7. UPDATE: For updating the Transmitters firmware.
8. DC IN: Connect the supplied 12V DC power supply.
9. POWER SWITCH: Switch the system (Transmitter and Receiver's) on/off.
Receiver
1. EQ: Use to adapt the Receiver according to the length of Cat.6 cable being used.
2. HDMI OUT: Connect to your HDMI display using a good quality HDMI cable.
3. IR IN: Connect the supplied IR Receiver.
4. POWER LED: Illuminates green when power is received from the Transmitter.
5. CAT: Connect to a Cat.6 cable to make the connection to the Transmitter.
6. LOCK LED: Illuminates orange when a stable signal is received from the Transmitter.
English
Werbung
