Inhaltsverzeichnis
Werbung
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer
in position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose
and threaded base and tighten the collar nut
by hand. If there is not enough space, please
use only the slide washer and the metall with-
out the plastic washer. Tighten screws.
4
If necessary shorten platic hose according to
the table and insert it up to the collar into the
shorter blue marked copper pipe.
5. Connect the shorter, blue marked supply pipe
to the angle valve.
Connect the longer blue marked pipe to the
inlet and the red marked to the outlet of the
storage tank.
Attention!*
With water heaters of 5 liters the flow rate at the
mixer should not exceed 5 l/min.
In this case the flow rate must be reduced at the
angle valve.
When the storage tank is being heated, the
spout will drip.
When changing the spray former, it is imperative
to use one made for this type of mixer.
max. permissible water pressure
on the spot
in bars
1 - 1,5
2 - 3
4 - 7
Hose lengths to be used
8, 10 and 15 liters
without hose
hose to be shortened to 90 mm
If pressure greater than 5 bar, fit pressure reducer.
English
Technical Data
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow with water heaters
of 5 liters:
Spare parts
1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge, assy
5
locking screw
6
aerator cpl.
7
spout
8
sealing set
9
fixation set
XXX = Colors
000 chrome plated
090 chrome plated/gold plated
750 alux
storage tank volume
hose unchanged,
reduce flow rate at the angle valve*
max. 10 bars
16 bars
max. 80° C
65° C
max. 5 l/min
up to 5 liters
hose to be shortened to 90 mm
hose unchanged
96652XXX
96338000
94192XXX
94194000
92730000
96059000
96653XXX
96654XXX
92646XXX
95049000
Werbung
Inhaltsverzeichnis
