Operation - Stilfer 527.003 Instruktionen Für Die Installierung, Benutzung Und Unterhalt

Vertical TOASTER
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
ATTENTION :
BEFORE THE INSTALLATION REMOVE THE PROTECTIVE COAT FROM THE STEEL.
INSTRUCTION FOR USE
Install the appliance in well-ventilated surroundings.
The appliance must be installed on a heat resistance top and ensure that the crumb collection tray is fitted

OPERATION

The appliance don't need a particular installation because fitted of plug ; it's enough that the socket or multi-
pole switch are easily accessible once the appliance has been installed
Connect the plug to a 220V.+ground socket.
Appliance pre-heating takes approximately 2 minutes. These times can be set by means of the timer. Once
the operating temperature has been reached, set toasting times as required.
For examples, for a toasted cheese sandwich, set the timer to 4/5 minutes.
The Toasters models have different toasting sections which can operate independently by means of the
relative timer. The heating elements are deactivated when the set timer is complete .
The quality and moisture of the bread influences toasting considerably. Dry bread will burn before the cheese
and ham are fully heated .
For optimal results, store bread in sealed container to avoid loss of moisture.
For evenly toasted bread with melted cheese, use sliced bread and cheese slices available commercially.
Toasting frozen sandwiches does not obtain satisfactory results as the bread tends to burn and the
cheese and / or ham does not heat. Defrost products beforehand.
IMPORTANT
Not special maintenance is required: simply check the condition of the cable .
In the event of appliance operation problems, contact qualified personnel for maintenance operations.
USE OF PLIERS
Pliers have opening in the inferior side . Lift pliers without press and when napkin is positioned to pick up
Toast press pliers and let it fall down.
CLEANING
WARNING : NEVER USE WATER JETS TO CLEAN THE APPLIANCE
IMPORTANT
Disconnect the appliances from the power supply before cleaning or maintenance .
Carry out through cleaning of the appliance regularly taking into account the following:
- clean stainless steel parts with suitable non-abrasive products available commercially. Never use
substances containing chlorine (bleach, etc.)
- do not use pads or detergent containing abrasive substances
- the heating elements are very fragile ; don't stumble, don't flex , don't clean .
527002-3-4 en-fr-de ma 2011
2
GB