Herunterladen Inhalt Inhalt Diese Seite drucken

Perform A Range Check; Take Off; After Flight; Technical Data - zoopa AA7210 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

zoopa Glider 75

Perform a Range Check

As a precaution, an operational ground range test should be performed before the fi rst fl ight each time out. Performing a range test is a good
way to detect problems that could cause loss of control such as low batteries defective or damaged radio components or radio interference.
This usually requires an assistant and should be done at actual fl ying site you will be using.
First turn on the transmitter. Then, install the fully charged battery into the fuselage and hold it in place with the hook-and-loop strap.
Connect the battery and install the hatch.
Remember, use care not to „bump" the throttle stick. Otherwise, the propeller will turn, possibly causing damage or injury.
With the antenna on the transmitter collapsed (not extended), begin walking away from the model operating the controls in a predictable
pattern (for example: Up, then down elevator. Right, then left aileron. Right, then left rudder). While moving the control surfaces, also vary
motor rpm. Have your assistant alert you if the controls fail to respond or if they move suddenly or erratically. You should be able to maintain
control up to a distance of approximately 100' (30 m).

Take Off

Until you have become comfortable with fl ying your plane, do not fl y if the wind speed is greater than 10 mph (16 km/hr).
One fi nal check before takeoff: always double-check the fl ight control response to your inputs from the transmitter before every fl ight.
Make sure the ailerons, elevator and rudder respond correctly and that none of the controls have inadvertently become reversed.
If the surface is smooth (such as paverment or blacktop) the plane can take off from the ground. But most grass is probably too tall, so if
fl ying from grass the model will have to be hand launched.

After Flight

Disconnect the battery and remove it from the airplane. Then, turn off the transmitter. Allow the battery to cool down before recharging,
or allow the motor to cool before installing another battery for the next fl ight. Inspect the airplane to make sure nothing has become loose
or damaged.

Technical Data

zoopa Glider 75, ARF (Art. Nr.: AA7210)
Wing Span:
758 mm
Length:
536 mm
Weight:
200g, incl. Battery
Level of Diffi culty:
Beginners
Propeller:
108 x 68
Wings & Rudder:
EPP carbon-reinforced
Receiver:
4-Channel
Motor:
208A Brushless Motor
ESC:
10A Brushless ESC
3 Servos:
Aileron – 1x
Elevator – 1x
Rudder – 1x
20

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für zoopa AA7210

Inhaltsverzeichnis