SIGLENT TECHNOLOGIES SDG2000X Schnellstart Seite 15

2. Channel Status Bar
Indicate the selected status and output configuration of the channels. Touch this area of the screen to switch to the corresponding channel. If you touch again, the
short cut menus of function keys will be recalled: Mod、Sweep、Burst、Parameter、Utility and Store/Recall.
3. Basic Waveform Parameters Area
Show the current waveform's parameters of each channel. Touch this area of the screen to highlight the parameter you want to configure, use number keys or knob
to change the parameter value.
4. Channel Parameters Area
Display the current selected channel's load and output settings.
Load ----Value of the output load, as selected by the user.
After choosing the parameter to highlight it, use the soft keys, number keys or knob to change the parameter value.
High Impedance: display HiZ.
Note: This setting does not actually change the instrument's output load impedance of 50Ω but rather is used to maintain amplitude accuracy into different load values.
Output ----Channel output state.
After touching this area of the screen or pressing corresponding channel output control port, you can turn on/off the current channel.
5. LAN Status Icon
The generator will show different prompt messages based on the current network status.
This mark indicates LAN connection is successful.
This mark indicates there is no LAN connection or LAN connection is unsuccessful.
Menu
6.
Touch here for the menu corresponding to the displayed function. For example, the picture above shows the parameters of "AM modulation". After touching the
menu on the touch screen to choose the corresponding parameter, use number keys or knob to change the parameter value.
Modulation Parameters Area
7.
Show the parameters of the current modulation function. After touching this area of the screen or pressing corresponding menu, use number keys or knob to
change the parameter value.
Load: display impedance value (the default is 50Ω and the range is 50Ω to 100kΩ).
15