Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Installation
1
(1) Remove the front cover of the housing by:
•
Inserting the screwdriver in the right-hand slot and
pushing downwards to lever the cover open
•
Inserting the screwdriver in the left-hand slot and
pushing downwards to lever the cover open
3
4
(4) Latch the 2 locking hooks of the front cover onto the locking webs of
the housing.
(5) Fold the front cover onto the housing.
(6) Latch in the cover audibly with a light pressure
14
4
(3) Drill the four holes, each 170 mm apart
You should use at least 2, better 4 fixing points to fix the RNG5-STD
securely on the wall.
5
EN0H-0474GE25 R0217
Install the device out of reach at a minimum installation
height of 200 cm.
The following tools are necessary for correct installa-
tion:
• Slot-head screwdriver for simple opening of the housing
cover
• Cross-head screwdriver or cordless screwdriver
• 5 mm stone drill bit for drilling the plug holes (5 mm) in
the wall
2
(2) Remove the installation material
When drilling ensure you do not damage any utility pipes or cables
(electricity, water, IT network, etc) laid in the wall.
6
7
(7) Seal the enclosed anti-tamper seal of
the gateway.
V1.0 / 09.03.2017
Werbung
Inhaltsverzeichnis
