Herth+Buss ELPARTS 95980775 Bedienhinweis Seite 41

Operating instruction 95980775
Measuring Capacitance
1. Connect the black test lead to the COM
jack, the red test lead to the jack.
(Note: The polarity of the red lead is positive
„ + „. )
2. Set the range switch to position.
3. Connect the test leads across the capacitor
to be measured.
4. Wait until the reading is stable, then read
the reading. ( For high-capacitance measure-
ments, it may take about 30 seconds for the
reading to be stable. )
Note:
Before measurement, make sure that the
capacitor to be measured has been dischar-
ged thoroughly. To improve the accuracy of
low capacitance measurement, subtract the
residual capacitance of the meter and test
leads by using relative measurement. For
the measurements ≥100 µF , the display will
show „OL " as overrange indication.
41