Beko HTV 8744 X00 Bedienungsanleitung Seite 35

There is detergent left on the laundry. (**)
• Excessive laundry was loaded in. >>> Do not load the machine
in excess.
• Wrong programme and temperature were selected. >>>
Select the proper programme and temperature for the laundry
to be washed.
• Wrong detergent was used. >>> Select the proper detergent
for the laundry to be washed.
Too much foam forms in the machine. (**)
• Improper detergents for the washing machine is used. >>>
Use detergents appropriate for the washing machine.
• Excessive amount of detergent is used. >>> Use only sufficient
amount of detergent.
• Detergent was stored under improper conditions. >>>
Store detergent in a closed and dry location. Do not store in
excessively hot places.
• Some meshed laundry such as tulle may foam too much
because of their texture. >>> Use smaller amounts of
detergent for this type of item.
• Detergent was put in the wrong compartment. >>> Put the
detergent in the correct compartment.
• Softener is being taken early. >>> There may be problem
in the valves or in the detergent drawer. Call the Authorised
Service Agent.
Foam is overflowing from the detergent drawer.
• Excessive amount of detergent is used. >>>>Mix 1
tablespoonful softener and ½ L water and pour into the main
wash compartment of the detergent drawer.
• Put detergent into the machine suitable for the programmes
and maximum loads indicated in the "Programme and
consumption table". When you use additional chemicals (stain
removers, bleaches and etc), reduce the amount of detergent.
Laundry remains wet at the end of the programme.
(*)
• Excessive foam has occurred and automatic foam absorption
system has been activated due to too much detergent usage.
>>> Use recommended amount of detergent.
35 / EN
Drying lasts too long.
• Excessive laundry loaded. >>>
in excess.
• Laundry is not spun enough.>>>
speed in washing step in the Dryer-Washing Machine.
• Tap is turned off. >>>
Laundry is still damp after drying.
• An appropriate programme according to laundry
type might is not selected.>>>
clothes and select an appropriate programme or use timed
programmes in addition.
• Excessive laundry loaded. >>>
in excess.
• Laundry is not spun enough.>>>
speed in washing step in the Dryer-Washing Machine.
Machine does not start or programme cannot be started.
• Power cable is not connected. >>>
cable is connected.
• Programme is not set or Start / Pause / Cancel button
is not pressed. >>>
it is not in Stand-by mode.
• Child lock enabled. >>>
Laundry is shrunken, pale, matted or damaged.
• An appropriate programme according to laundry type is
not selected.>>>
Check care labels on clothes and select an
appropriate programme or use timed programmes in addition.
You must not dry clothes that are not suitable for drying.
Machine does not dry.
• Laundry is not dried or drying step is not enabled. >>>
Check if drying function is selected after the selected washing
programme.
Loading door cannot be opened.
Your machine's door is not opened for safety
reasons.>>>
If door locked indicator is still active on display
after drying, machine keeps the loading door locked until it
cools for your safety.
(*) Machine does not switch to spinning step
when the laundry is not evenly distributed
in the drum to prevent any damage to the
machine and to its surrounding environment.
Laundry should be rearranged and re-spun.
(**) Regular drum cleaning is not applied.
>>> Clean the drum regularly. See 6.2
A
CAUTION!
• If you cannot eliminate the problem
although you follow the instructions in
this section, consult your dealer or the
Authorised Service Agent. Never try to
repair a nonfunctional product yourself.
Do not load the machine
Spin at a higher spin
Turn on the taps.
Check care labels on
Do not load the machine
Spin at a higher spin
Make sure the power
Make sure the programme is set and
Disable Child lock.
Washer-Dryer / User's Manual