Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Original Instruction Manual
c) Do not allow hands or any other part of the body or clothing inside the feeding chamber,
discharge chute, or near any moving part.
d) Keep proper balance and footing at all times. Do not overreach. Never stand at a higher level
than the base of the machine when feeding material into it.
e) Always stand clear of the discharge zone when operating this machine.
f) When feeding material into the machine be extremely careful that pieces of metal, rocks, bottles,
cans or other foreign objects are not included.
g) If the cutting mechanism strikes any foreign objects or if the machine should start making any
unusual noise or vibration, immediately shut off the power source and allow the machine to stop.
Disconnect the machine from the supply and take the following steps before restarting and
operating the machine:
i.
inspect for damage;
ii.
replace or repair any damaged parts;
iii.
check for and tighten any loose parts.
h) Do not allow processed material to build up in the discharge zone; this may prevent proper
discharge and can result in kickback of material through the intake opening.
i) If the machine becomes clogged, shut-off the power source and disconnect the machine from
supply before cleaning debris.
j) Never operate the appliance with defective guards or shields, or without safety devices (for
example debris collector in place), or if the cord is damaged or worn,
k) Keep the power source clean of debris and other accumulations to prevent damage to the power
source or possible fire.
l) Do not transport this machine while the power source is running.
m) Stop the machine, and remove plug from the socket. Make sure that all moving parts have come
to a complete stop,
whenever you leave the machine;
-
before clearing blockages or unclogging chute;
-
before checking, cleaning or working on the machine;
-
after striking a foreign object to inspect the machine for damage;
-
if the machine starts to vibrate abnormally, for immediately check;
-
n) Do not tilt the machine while the power source is running.
o) Always be sure of your footing on slopes. Walk, never run.
p) Keep extension cords away from moving hazardous parts to avoid damages to the cords which
can lead to contact with live parts;
6
GB
02/2018
Werbung
Kapitel
