Automatic Drive + Turnout; Software Update; Technical Specifications - Massoth DiMAX 8130001 Bedienungsanleitung

successful programming procedure! Programming may be faulty
although the check mark is shown. No feedback is available during
address programming. The menu must be exited after each address
programming.
4.8. Automatic driving + automatic switch operation
These functions are not usable with Xpressnet.

5. Software update

The DiMAX Multi Receiver may be updated at any time using the
Massoth PC module 100A. Connect the PC module to the Massoth
terminal and update the firmware. No other component should be
connected to the receiver during updating. In case you cannot update
the receiver, your dealer will gladly help. In addition Massoth
Electronics may do an upgrade for a low service charge.
Start the DiMAX PC Update software and open the current update file
for the receiver. Select the COM-port in use. During the update the
red LED will flash. After the update the receiver is ready for operation
with the new software version.
In case of a malfunction during updating, the PC will display a
warning and the updating process will be terminated. The receiver
will be in the update mode if switched on again. This is shown by the
fast blinking red LED.

6. Technical Specifications

Power Supply: 12 to 24 Volts DC (depend on central station)
Current: 30 mA in idle
Frequency range: 915,0 – 918,0 MHz
Transmitting output: max. 9,5 mW
Temperature range: -4°F to +113°F
Measurements: 68 x 78 x 20 mm (L x W x H)
Note regarding the operating temperature: to prevent the production of condensed wa-
21 DiMAX Multi-Funkempfänger / Multi-RC Receiver – 8130001