Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The options are explained as follows:-
To end, use OPTION UP to get to option '00 FINISHED? OK?' Press OPTIONS FINISHED to
go back to the OPTIONS/NEW display. Use ESC to go back through the menu levels to
RUN/SET.
QCommander Replica
To change the system options, select OPTIONS. Scroll down the list of options
using the OPTION DOWN button and up the list with the OPTION UP button. Press
the OPTION ON-OFF button to de-select a selected option. Press the OPTION OFF-
ON button to select a de-selected option. Press OPTIONS FINISHED? OK? to return
to the OPTIONS/NEW display.
01 Autoplay ON/OFF. Default = OFF. The Replica may be set up to automatically
play back the contents of a previously-selected output button immediately power is
applied: the button will have been previously selected using option 14.
02 MenuTimer ON/OFF. Default = OFF. With the menu timer ON, the display reverts
to RUN/SET after 30 seconds if no further buttons are pressed.
03 CommsMode MID/232. Default = MIDI. RS232 not yet implemented.
04 BlackAll ON/OFF. Default = OFF. Only channels of the type shutter and Dimmer
are affected by the operation of the Blackout switch. When set to ON, all channels go
to 0 when the blackout button is pressed.
05 Send MIDI ON/OFF. Default = ON. Must be set to ON to enable MIDI out.
06 MIDIrxchn 0-15. Default = 0. The button OPTION OFF-ON increases the channel
number; OPTION ON-OFF decreases the channel number.
07 MIDIOmni ON/OFF. Default = OFF. When set to ON, the Replica receives on all
channels 0-15.
08 ScnsFade ON/OFF. Default = OFF. Fade-out times on static scenes are ignored,
as they could clash with fade-in times on subsequent scenes.
09 InstSY&FX ON/OFF. Default = OFF. When set to ON, the installation of a new
system also updates the fixture library.
10 RptShow ON/OFF. Default = OFF. A show may be set to run just once or to loop
continuously until manually switched off by setting this option to ON.
11 AskStrike ON/OFF. Default = OFF. This option may be set to ON to allow for
those intelligent fixtures which must be specifically switched on before use. If set to
ON, you are asked after the opening QReplica screen whether you wish to strike the
lamps.
12 AutStrike ON/OFF. Default = OFF. Set this option to ON to automatically strike
the lamps of those fixtures that require to be specifically switched on.
13 P-showBlk ON/OFF. Default = ON. Calls a blackout before a show runs.
14 Startkey 001. Default = 0. Choose a key for the autoplay option. See option 01.
15 MIDIOffset 000. Default = 0. The default MIDI map starts at note 0, applying to
button 1 on bank 1. An offset may be applied using this option, using the OPTION
OFF-ON and OPTION ON-OFF buttons.
16 Erase mem OK? Resets all options to default. Empties all memories.
Page 4
English, Français, Deutsch, Español
Werbung
