Regulation And Programming - Nova Florida Simun EA series Installations- Und Instandhaltungsanleitung

6.

REGULATION AND PROGRAMMING

The control panel has two regulation knobs (see fig. 2).
knob 2
There are 5 available functions or operation modes to chose from: Comfort,
knob 1
Night-time reduction, Anti-freeze, Pilot wire (only for France), Stand-by.
LED
Switching on and mode selection can be made through knob 1: when the
radiator is operating the internal electrical resistor is on, the LED is on (red);
when the LED is green the resistor is not pulling power.
The second knob can be used to programme the room temperature.
fig. 2
Comfort Mode
This is the normal mode for using the radiator to keep the room temperature at the programmed level. The programmed temperature depends on
the position of the temperature control (knob 2).
As an indication, the programmed temperature and the numbers shown on the knob correspond to the values shown in fig. 3:
fig. 3
When set at the angle between 0º and 9.5º, the programmed temperature is around 7ºC.
Night-time reduction mode:
When the mode control is in this position, the programmed temperature will be 3.5ºC lower than the temperature programmed on the
temperature knob at that time.
Anti-freeze mode:
When this mode is selected, the programmed ambient temperature is 7ºC. Turn knob 1 to position and slowly rotate knob 2 anti-clockwise
until the end of its stroke. The LED stays green even if the resistor is activated
Off mode:
When the mode control is in this position, the radiator is turned off. The LED light is off.
NB: The radiator is still pulling power in this position.
Pilot wire mode:
This mode enables the user to control the radiator from a remote control unit.
The temperature setting will depend on the pilot wire controls and the position of the temperature potentiometer.
This mode can be only used in radiators installed in France.
18