Operation; Protection Against Overheating; Maintenance; After-Sales Service - Ventur COR-F-1000 N Gebrauchs- Und Montageanweisung

OPERATION

REMOTE CONTROL CONNECTION. (This control is incorporated in the packaging of
each air curtain).
CURTAIN MODEL
COR- F-1000 N
COR- F-1500 N
COR- F-2000 N
COR-3,5-1000 N
COR-6-1000 N
COR-9-1000 N
COR-9-1500 N
COR-12-1500 N
COR-18-2000 N
IF CONNECTION BETWEN TWO OR MORE AIR CURTAINS OF THE SAME MODEL
(MAX. 5 UNITS), PLEASE REFER TO WIRING DIAGRAM FROM FIG. 5
NOTE:
In the case of multiple connection, Installer must consider the increased number of
feeders based on the number of connected units. In order to interconnect two or more
curtains it is
predicted that the cables can go through their interior. FIG 3 (c) shows a lateral cover on
which a noticeable circular opening is present. This opening allows easy breakage, thus
enabling the installer to feed cables to the unit.

PROTECTION AGAINST OVERHEATING

The COR Air Curtains are fitted with one thermal fuse which automatically disconnects
the unit in case of overheating.
In the event of this happening please contact the official S&P dealer in your area.

MAINTENANCE

The COR Air Curtains do not need any special maintenance, but it is recommended to
keep the inlet and outlet grilles clean. Clean them with a dry cloth (avoid using solvents
or abrasive
detergents). Once a year, the inside parts should be cleaned by a qualified electrician
using compressed air or a vacuum cleaner. Disconnect the unit from the mains supply
before carrying out this operation.
AFTER SALES SERVICE
In case of any problem with the unit, it is advised to contact your S&P dealer. Any ma-
nipulation of the appliance by personnel not appointed by S&P will cancel the guaran-
tee.
S&P reserves the right to modify the product without prior notice.
REMOTE CONTROL MODEL
CR-F
CR-3,5 N
CR-6/9 N
15