Baker Hughes PACE 6000 Bedienungsanleitung Seite 6

Pneumatic Connections
In the event of a power failure or other fault condition the customers system should have
other means for indicating pressure in pressure lines connected to the PACE.
Fit manual vent valves to pressure lines connected to the PACE +ve source input port and
output port to allow safe venting to atmosphere of these pressure lines in event of power
failure or other fault condition.
WARNING
pressure lines before disconnecting or connecting the pressure lines.
Proceed with care.
Only use equipment with the correct pressure rating.
Before applying pressure, examine all fittings and equipment for damage.
Replace all damaged fittings and equipment. Do not use any damaged
fittings and equipment.
Do not exceed the maximum working pressure of the instrument.
This equipment is not rated for oxygen use.
Electrical Connections
RISK OF ELECTRIC SHOCK
connected to the AC supply protective safety ground.
Isolate the power supply before making any electrical connections to the
rear panel.
Packaging
Check the contents of the PACE5000/6000 packaging with the list that follows:
Packaging List
i. PACE5000 or PACE6000 Pressure Controller.
ii. Cable, power supply.
iii. User guide and CD (UD-0001) containing the full documentation suite.
iv. Pneumatic Control Module blanking plate (keep this plate for future use).
CAUTION
the flow of cooling air.
After unpacking an instrument that has been in cold conditions allow time
to stabilize and any condensation to evaporate.
2 | PACE5000/6000 Safety Instructions and User Guide-English
Turn off the source pressure(s) and carefully vent the
After removing a control module, use a blanking plate to keep
The ground lead of the instrument must be
© 2008 Baker Hughes, a GE company – All rights reserved.