Telex Electro-Voice RE-2 Betriebsanleitung Seite 9

Section 4 - Receiver Display Screens and Functions
Main Operating Screen
Display:
1. Group Number . . . . . . . . . . . . . .10 (factory set)
2. Channel Number . . . . . . . . . . . . . . . . . .01 to 10
3. Frequency . . . . . . . . . . .Displayed in MegaHertz
4. Battery Status . . . . . . . . . . . . . . .100 to 0 Pct in
25 Pct steps/Flash if low
5. Audio VU Meter . . . . . . . . . . .-30 VU to + 3 VU
6. RF Signal Strength . . . . . . . . . .1 µV to 100 µV
7. Antenna Diversity Status . .left or right antenna
8. ClearScan . . . . . . . .Indicates Scan is in progress
9. Guitar Symbol . . . . .Indicates Instrument Mode
Squelch Adjustment Screen
Display:
1. Squelch Level . . . . . . . . . . . . . . . . . . . .1-10
Transmitter Display and Controls
Figure 10
Transmitter Display and Controls
Figure 8
Main Operating Screen
1. Press and hold SET for 3 seconds starts Auto
ClearScan™
2.
Press SET once, Group starts flashing, adjust
with UP and DOWN.
2.a With Group flashing, press and hold SET for 3
seconds to start Group Scan
3.
Press SET twice, Channel starts flashing, adjust
with UP and DOWN.
3.a With Channel flashing, press and hold SET for 3
seconds to start Channel Scan
4.
Press SET and UP at the same time to enter
Frequency Mode
5.
Press and hold UP for 3 seconds to adjust
Squelch
6.
Press and hold SET during power up to enter
Instrument Mode
7.
[UP] + [DOWN] for 3 seconds Sets/Resets
Edit Lock out
Figure 9
Squelch Adjustment Screen
1. [UP] + [DOWN] adjust the squelch level
2. SET saves the squelch level shown and
returns you to the main screen
Display
1. Group and Channel
2. Battery Level in Percentage
3. Frequency
Controls: 1. Press SET once, GP will flash, use UP and DOWN
to adjust
2. Press SET again to accept GP, CH will flash, adjust
with UP/DOWN
3. Press SET again to accept CH and channel will be installed
4. Press SET and DOWN at the same time to change
display mode
5. Press SET and UP to enter Frequency Set Mode
6. Press SET and DOWN to return to the
Group/Channel Mode
7. Press and hold UP and DOWN for 3 seconds to
lock out SET
8. Press and hold UP and DOWN again to activate SET
9. Press and hold UP, DOWN, and SET to lock power
(see Section 4)
10. Press and hold UP, DOWN, and SET to unlock
power.
- -
7
English
Controls:
Controls: