Vax Floormate Deluxe Bedienungsanleitung Seite 6

Using your Floormate Deluxe: emptying the recovery tank
NOTE:
The recovery tank has an automatic shut off to prevent the tank from overflowing. If this is activated, the machine will not pick up and the sound of the motor
will change. The recovery tank will need to be emptied.
1 2
To remove
recovery tank,
press down on
release button
and pull.
Using your Floormate Deluxe
TIP
To enhance drying on the floor
surface, release trigger and continue
to move machine over the area to
pick up dirty solution.
5
The mode selector allows you
to choose DRY mode or WET
Mode. DRY mode raises the
SpinScrub brushes off the floor
and also stops them spinning.
6
3
Remove Unclip latches
recovery tank lid on tank lid to
to empty. separate from
the tank.
1
Push switch to turn
machine on, push
switch again to
turn machine off.
6
WASH mode lowers the
SpinScrub brushes which
makes contact with the floor for
scrubbing action.
4
Pour dirty water
into sink.
2 3
Step on handle
release pedal to
recline machine.
7
In WASH mode slowly move the
machine forward to arms length
squeezing the trigger to release
the solution. Release trigger and
pull back machine to pick up.
5 6
Clean dirt and
debris from foam
filter. Foam filter
can be rinsed with
water (Max 40�C).
4
To move your machine
from room to room, put
the handle in the upright
position and tilt machine
back on rear wheels.
8
To remove those tough stains,
apply extra cleaning solution
by pressing the solution trigger
with the clean boost trigger at
the same time.
Tilt tank into
position and
push firmly until
clicks into place.
The machine can also
be moved by lifting
the machine using
the carry handle
on the front.