Installation; Wall Mounting; Electrical Connection - oventrop Datalog CS-BS-1 Montage- Und Bedienungsanleitung

3

Installation

AttENtION! ESD damage!
Electrostatic discharge can lead to damage to electronic com-
ponents!
Î take care to discharge properly before touching the
inside of the device. to do so, touch a grounded sur-
face such as a radiator or tap!
The Datalog CS-BS-1 comes with mains adapter and S-Bus cable already connected
to the device.
The housing does not have to be opened in order to mount the device.
Initial installation must be effected by the system installer or qualified personnel
named by the system installer.
3.1

Wall mounting

112mm
1
Note
Strong electromagnetic fields can impair the function of the device.
Î Make sure the device as well as the system are not exposed to strong
electromagnetic fields.
The unit must only be located in dry interior rooms.
In order to prevent disturbances caused by electromagnetic fields, pay attention to
separate routing of mains cables and bus cables.
2
3.2

Electrical connection

Carry out the connection of the device (pos. 1) to the controller / other
modules in the order described below:
Î Connect the data cable (S-Bus, pos. 3) to the controller (pos. 4). If necessary, ex-
tend the cable using the terminal block included and a common two-wire cable.
Î Connect the mains adapter (pos. 2) to the mains socket.
Î For a direct connection to a router, connect the device to a router (pos. 7)
using the network cable (included with the Datalog CS-BS-1, pos. 6).
Router
7
6
Power supply is carried out via an external mains adapter (terminals  and ). The
supply voltage of the mains adapter must be 100 ... 240 V~ (50 ... 60 Hz).
The Datalog CS-BS-1 comes with the mains adapter and the S-Bus cable pre-con-
nected.
1
2
4
3
21