Electrical Connections 210 Pm/M-E - Lamborghini Caloreclima 55 PM/M-E Installations- Und Wartungsanleitung

ELECTRICAL CONNECTIONS 210 PM/M-E

The installation technician should perform connections to the mains, thermostat line (TA-TC-TS-TMF) and safety
light if present.
LEGEND
Motor relay coil
BRM
Thermal relay contact
CT
C.CT Connector seal check
C.VE.PG Connector gas valve-gas pressure
EC Control electrode
F Fuse
FA Anti-interference filter
IG Main switch
ON/OFF switch
Ima
Lamp presence flame
LP
Lamp operation
LF
LR Lock-out warning light
LR1 Lock-out warning light (option)
MB Burner motor
If operating with a three-phase 220/230 V power supply without neutral, a connection jumper must be made between terminals
L3 and N of MR.
If operating with TMF, it is necessary to remove the connection jumper between terminals 1 and 4 of the MR terminal board.
When operating with CONTINUOUS MODULATION using a LANDIS RWF 40 regulator, remove the connection jumper between
terminal 9 - 7 of MR.
N.B. The connection from probe S to terminal G of MRM is required only with the pressure probe (LANDIS QBE...)
DO not exchange the neutral with the phase wire. Make proper earth connections..
COMPLY WITH GOOD ENGINEERING PRACTICES AND OBSERVE THE REGULATIONS IN FORCE.
Gradual two-stage operation Continuous modulation operation
Two-stage operation modulation
MMS LANDIS SQN... servo control terminal board
LANDIS LFL control box terminal board
MPE
Electric panel terminal board
MR
LANDIS RWF 40 - Modulation regulator terminal board
MRM
Air pressure switch
PA
PGm Minimum gas pressure switch
PS Reset button
RM Motor relay contacts
RT Thermal relay
S Sensor
Boiler thermostat
TC
2nd stage modulation thermostat (option)
Tmf
Ignition transformer
TR
Safety thermostat
TS
VE Gas valve
60