How To Use; Specification - SOLIS comfort line 430 Bedienungsanleitung

Diagram
Warning: installation must be carried out by a qualified electrician.
1. Drill two holes 6 mm in diameter 94.7 mm apart (see picture 2). Insert rawlplugs into the holes and
fix the hanger to the bottom hole with a screw. Then hang the bracket up and secure with a screw
in the top hole.
2. Remove front cover (5), and take out the panel (2) (see picture 3).
3. Electrical connection:
Connection to the mains: attach the mains connection to the connector strip (2) and clamp it down
with a wire clamp (3) (see picture 4).
When flush-mounted: open up the base as intended (1) and connect power supply (220-240V) to
the connector strip (2) (see picture 4).
4. Check the installation diagram and make sure the panel and front cover are secure.
5. Turn on power and master switch.
Pic. 2
1. Rawlplug
2. Screw
3. Cover panel
4. Hanger
5. Screw
Pic. 3
1. Screw 1
2. Panel
3. Cover panel
4. Screw 2
5. Front cover
Pic. 4
1. Wire entry opening
2. Fastener
3. Cable clamp

How to use

Switch on the power and remove the dryer from the bracket. The dryer will work when the power
button (2) is pushed in. Move heat setting button (1) up or down to alter the heat setting.

Specification

Voltage: 220-240V ~ 50Hz
Power: 1'200W max.
Shock protection:
955-20_ComfortLine-Betriebsanleitung.indd 15
1
2
3
4
5
Pic. 2
1
2
3
4
5
Pic. 3
1
2
3
Pic. 4
15
07.08.14 13:52