Goclever HCAMNAN2 Schnellstartanleitung Seite 7

CAUTION
Our device uses Smart Link technology, therefore
you should check if your Internet connection mode is
supported.
1. The WiFi password MUST be WPA or WPA2. WEP is
not secure and will not be recognized.
2. If your router is a dual band router, meaning it
supports both 5.0Ghz and 2.4Ghz networks, be sure the
SSID (network name) is different for each. You will need
your mobile device to be connected to the 2.4Ghz during
setup, the system only supports 2.4Ghz, not 5.0Ghz.
3. You must be connected to router or modem. We
cannot guarantee success with extenders, boosters, hot
spots, etc.
4. If you need further guidance regarding setting
network connection, you should contact your Internet
supplier.
MOST COMMON PROBLEMS
PROBLEM
Neither blue nor red
light is flashing, no
voice signal at the
start of device
Blue light is flashing
but I cannot connect
the camera
Red light is flashing
but I cannot connect
the camera
POSSIBLE SOLUTION
You should check if the device is
plugged in correctly.
Check if the WiFi information is
correct.
Check if the WiFi information is
correct, restart your router and
try again.
GB
6