Troubleshooting; Maintenance - Comsafe Mobil-Control Bedienungsanleitung

1-10 Mobil-control-2.09 PRINT:1 – 8
3. Select Currency Exit Direction
The banknote exit direction is selectable, press the EXIT
Direction Key, the exit direction will switch over between
Forward and Backward, and the corresponding Direction
Indicator turns on. The power on default exit direction is
forward, this means the currency will exit from the rear.
When a suspicious note is detected, it will always be
withdrawn from the Entrance.
If an suspicious note is dedected, the throw off this note
is OPPOSITE the selected Currency Exit.
4. Reset Detecting Data
The number of sheets and total value can be reset to zero
by hold the currency Exit Direction Key for about
2 seconds. Note: only the data of the currently detecting
currency is affected, and the data of another currency will
not be cleared.
III. Operation Instruction
1. Working with AC/DC adapter
Please plug the attached power supply adapter into main
supply, and then connect the DC output plug into the DC
socket on back of the machine, The machine will auto-
matically start and perform a self-testing routine, then '0'
display on both Number of Sheets Display and Total
Value Display , now the machine is ready to work.
2. Working with built-in battery
When working with built-in battery, the user needs to
press the Power On/Off Key and hold it for about
2 seconds to power on the machine.
3. Detecting
When the machine detects an insertion of banknote in
Entrance , It will automatically start the motor and begin
a detecting procedure.
There is no limitation on side or direction (it's not includ-
ing Swiss Franc, Swiss Franc should be put via certain
direction: the side with black serial No. should be facing
operator and against the right edge). When inserting
notes, banknotes should be put in straightly.
If the banknote is a genuine one, the number of sheets
will be increased and the corresponding total value
added. When the number of sheets is above 999 or the
total value is above 9999, the data will be automatically
reset to zero.
If the banknote is a suspicious one, it will be rejected
(withdraw from the Entrance ) and 3 beeps given, corre-
spond alarm code will be displayed on Number of Sheets
Display for a brief time.
4. Sleeping (Power Saving) Mode
When the machine is supplied only by built-in battery, in
this case, the machine may enter sleeping mode after 5
minutes of idle in order to save power.
When the machine is in sleeping mode, the currency
indicator (for example EURO Indicator ) and the currency
Exit Direction Indicator will flicker at an interval to remind
Mobil-5.06 print 25.02.2009
the user that the machine is now in sleeping mode.
The sleeping mode can be waken up and return to work-
ing mode by inserting a banknote in the Entrance or by
pressing the Power On/Off Key .
Before getting into sleeping mode, the Number of Sheets
Display will display "-Pd" for a brief time to remind the
user now the machine is about to enter sleeping mode.
5. Battery Status Message
When the machine is charging the battery, the Number of
Sheets Display will display "-Ch" at an interval to indicate
the battery is being charged. Usually it needs about 15
hours or more to make the battery be fully charged.
If the battery is low, the Number of Sheets Display will
display "-Lo" at an interval to remind the user the battery
needs to be charged or the user should shut down the
machine.
IV. Alarm code
When a suspicious note is detected, The Number of
Sheets Display will display the error message as follow-
ing:
-E1 : length failure
-E2 -E3 : magnetism feature failure
-E4 -E5 : infra-red feature failure
V. Troubleshooting
1. If the machine keeps alarm or works abnormal, Check
the following:
Whether the main power supply is within specified range:
AC 100V~ 240V/50~60Hz
Whether the DC output is within specified range: DC 12V
Whether the supply plug is well connected.
When working with battery, whether the battery is suffi-
cient.
Keep away from high magnetic affection.
Clean the dust on the sensors.
2. If a note is blocked while testing, please open the top
cover and take off the note and test again.
3. Please smooth the note before testing, and notes must
be put in straightly while inserting.
VI. Maintenance
This machine is a precise financial detecting equipment,
and it needs frequently maintenance.
1. Periodically check the voltage of the power supply to
ensure that the voltage is within the specified range.
2. Keep the machine in ventilated place and beyond inso-
lating and magnetic field.
3. Periodically clean the sensors: use a piece of cotton
with a small amount of alcohol to clean all sensors, rub-
ber wheels and non-slip rubber belt. Keep the surface of
sensor away from sharp and hard articles to prevent
damage.
COMSAFE MOBILE CONTROL
12:55 Uhr Seite 7
7