Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preparations
Remove the screws from front lid and cover plate . Lift the lid and unplug the LED connector
on the right side of the PowerVX. Be sure to work in a dust-free ambient, so the optical
section is not contaminated. Now safely store the top cover and avoid touching the output
window. During aligning process, also make sure not to touch any optical surface with sour
fingers. Inside the PowerVX, high quality optical components are used, and not all optical
surfaces can be cleaned the usual way. Most of the mirrors are very high reflective protected
silver mirrors, cleaning is not recommended. If, in any case, the surface is dirty, it is
recommended to replace the mirror.
Apply an input signal to the DB25 ILDA connector on the back of the PowerVX. You can
either do this with an external power supply or a standard laser software by projecting a white
dot or small circle.
All PowerVX RGY models:
Now adjust the red laser line in the same procedure. Align both beams properly on top of each
other, parallel onto the galvo mirror mount, and, at the same time, parallel in far distance.
Finally, all single beams and colors should match on the galvo mirrors and also after a
distance of 10-20m. Once the system is aligned, it should not misalign again. During
alignment procedure, please check all mirror mounts for proper function and cleanness.
Basically there are two laser devices for red and
green color. Depending on output power and
setup of the PowerVX projector, there different
laser modules are used, which are coupled and
aligned to one single beam. But in any case,
each single color is mixed to one beam, before it
enters the main optical mixing section.
Procedure is quite easy, but should only be done
by an experienced service technician. All color
lines must be parallel from the last dichroic filter
on the red laser to a distance of minimum 10m
projection size.
The green laser beam is your reference of the
optical mixing system. Adjust the green beam
with the mirror mount. Make sure, the beam is
parallel to the base, and hits the galvo mirror
properly.
9
Werbung
