Assembly Of The Twinning Set On The Bottles - METALSUB TWINNINGSET Montageanleitung

2
Assembly of the twinning belt on the bottles (fig. 4,5,6)
Figure 4.
C A
1. Slide the twinning band to the desired height over the cylinders with the m8 nut at the
rear. Make sure that the Metalsub logo is not upside down. if necessary, first remove
the base of the bottle or the bridge.
2. Fig. 4: Place the two twinning plates on the twinning band. The twinning band slips into
the recess of the twinning plate.
3. Fig. 4A: Place the synthetic spacer in the recess left for them in the twinning plate.
4. Fig. 4B: Slide both threaded ends through the spacers with the pre-mounted m8 nut
and the synthetic washer on the backpack side.
5. Fig. 4C: Tighten the twinning nuts as tightly as you can by hand onto the threaded ends
of the bolts.
Fig. 5-6: Now alternately screw the two twinning nuts and the m8 nut tight until you
6.
reach a tightening force of 4-7Nm for the two twinning nuts and 6-8Nm for the m8 self-
locking nut on the twinning belt.
Important: While thightening the nuts, make sure that both bottles remain flat and
parallel so no unnecessary pressure is exerted on the bridge.
Figure 5.
A
Figuur 3
Figure 6.
B
ENG ENG
7