Assembly Instructions; Mounting The Backpack Holder On The Backpack - METALSUB TWINNINGSET Montageanleitung

ASSEMBLY INSTRUCTIONS

1
Charging the battery pack (fig.3)
1.
Choose the right packing rubber. The twinning set is supplied with two
types of rubber packing that has to be inserted between the backpack
holder and the backpack. The round one is used if the back of your
backpack is concave, use the flat one if the back of your backpack is
flat.
2. Mount the backpack holder at the desired height, with the pressure pin
on top. Screw the self-locking nuts on the bolts sufficiently tight without
causing distortion of the backpack if this is made of synthetic material.
Depending on the thickness of your backpack, it may be necessary to
shorten the bolts but make sure you leave enough thread for the self-
locking nut!
6
Figure 3.
.