Operation - Peaq PDR200 Bedienungsanleitung

Operation

TURNING THE UNIT ON
Press the button to switch on the unit.
ADJUSTING THE ANTENNA
For optimal reception, extend the antenna,
move to fully extend and adjust it.
ADJUSTING THE VOLUME
The volume can be adjusted during playback
with the volume control.
There are two ways to connect the radio to
PDR200_A5_131219_1.indb 41
Internet-radio configuration
the internet using an access point:
• Wireless in WLAN-Mode
The WiFi-antenna of the radio receives
your DSL router signals.
• With cable using the radio's LAN con-
nection in LAN-Mode
provided an ethernet network is
available.
WLAN-MODE CONFIGURATION
If you have a wireless network, the WLAN
mode is the direct way to connect your radio
to the Internet:
1. Simply switch the radio on and, as a
cable-free network client, it automati-
cally searches all available APs (Access
Points).
2. When switching on for the first time, you
must confirm the AP and perhaps enter
the key. After that, the radio will always
access this AP. If the AP can no longer
be found, it will be registered accordingly.
LAN CONFIGURATION
If you do not have a wireless network but do
have a cabled network, you can connect the
Internet radio with a network.
1. Switch the radio off.
2. Connect an Ethernet cable to the LAN
socket. Once switched on and choose
wired. The radio will automatically be
recognized as a cable client.
ENGLISH
41
19/12/13 10:39 AM