Werbung
LS 200
Using the remote control
1. Insert the batteries
Insert two 1.5V size AAA batteries into the compartment of the remote control. Make sure
the polarity of the battery must be complying with which on the compartment.
Notice:
Do not use old battery together with new one.
Do not throw the remote control down on the ground or tread on it.
Please put out the batteries from the compartment when you do not use it for long extent
of time.
2. Effective scope of the remote control
The remote control is effective in a scope, which is less than 7 meters, and in an angel of 30
degrees from the remote control to the receiver in the center speaker.
Notice:
Do not put the remote control and the signal receiver under strong light.
Do not place any barrier between the remote control and the receiver.
Do not use this remote control at the same time when using any other one.
Operation
A. Switch On/Off the Product
1. Before turning on the system, please connect it according to the System Connection
Instruction.
2. Connect AC power supply with this product. (Caution: Power source must be consistent
with this product.)
3. Press on the POWER switch button on the Rear Panel of the main unit to switch on the
system, the standby indicator will light up. Then press the STANDBY button on the remote
controller to enter the normal status. Press the button on the remote controller once
again to keep power in standby status.
4. The device will get into standby mode automatically when there is no input signal
detected within 2 minutes. Press "STANDBY" button on remote control to wake up.
B. VOLUME Selection
1. Press the VOL + button on the front of the main unit, or the VOL + button on the remote
control to increase the volume.
2. Press the VOL - button on the front of the main unit, or the VOL - button on the remote
control to decrease the volume.
C.
TREBLE Selection
1. Press the TREBLE + button on the remote control to increase the treble level.
2. Press the TREBLE - button on the remote control to decrease the treble level.
D. BASS
Selection
1. Press the BASS + button on the remote control to increase the bass level.
2. Press the BASS - button on the remote control to decrease the bass level.
35
Werbung
