Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
P P R R O O G G R R E E S S S S P P C C 7 7 2 2 2 2 0 0 , , P P C C 7 7 2 2 6 6 0 0 , , P P C C 7 7 2 2 7 7 0 0 , , P P C C 7 7 2 2 8 8 0 0
English
DESCRIPTION OF PARTS
1. Suction inlet
2. Dust container indicator
3. Variable power control
4. Cable rewind button
5. On/off switch
6. Wheel
7. Dust container
8. Carrying handle
IMPORTANT SAFEGUARDS
Ø Read this instruction booklet carefully.
Ø Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate.
Ø Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug. Do not try to repair the appliance by yourself. For
repairs and accessories we are at your service from Monday to Friday from 8am to 6pm
Progress Serviceline : 01805-306080 (Deutsche Telekom 0,12 Euro/min.)
Ø Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations.
Ø Never leave the appliance unattended when it is switched on. Keep the appliance out of reach of children.
Ø This appliance is for domestic use only. Use as described in this instruction booklet.
Ø Do not pull the appliance by the cord. Do not unplug by pulling on the cord. Do not use the cleaner with a damaged cable. If the cable damaged, it
should be replaced at a service center. This is not covered by the warranty.
Ø Do not use appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts. Do not vacuum up any highly flammable or explosive
substances or gases.
These materials can cause serious damage to the motor - a damage which is not covered by the warranty.
Ø Do not unplug the vacuum cleaner with wet hands.
Ø Do not operate the vacuum cleaner too close to heaters and radiators, stoves etc.
Ø Before you start using the vacuum cleaner, please remove large or sharp objects from the floor to prevent damage to the dust container and hose.
INSTRUCTIONS FOR USE
Ø Before placing into operation make certain that the filters are in the proper position.
Ø To connect the hose into the suction inlet push it until it clicks (fig. 18).
Ø To disconnect the hose from the suction inlet push the button at the end of the hose (fig. 18).
Ø Unwind a sufficient length of cable and insert the plug into the power socket. A YELLOW mark on the power cable shows the ideal cable length. Do not
extend the cable beyond the RED mark.
Ø Press the ON/OFF button to switch the appliance on. On initial start up full power is reached after approximately 1-2 seconds.
Ø To rewind the power cable, press the rewind button with foot, and guide the cable with hand to ensure that it does not whip causing damage.
Ø By moving the variable power control, the suction power can be adjusted.
MAINTENANCE
REMOVING THE CONTENTS OF THE DUST CONTAINER
Never operate the cleaner without the dust container installed.
The dust container must be emptied if the window of the dust container indicator changes into red when the cleaner is operating at maximum
power and the nozzle is raised from the floor.
Never open the top cover with the hose connected to the cleaner.
Ø Open the top cover (fig. 19).
Ø Remove the dust container from the cleaner (fig. 20).
Ø Remove the filter set from the dust container by taking it in the way indicated in the icon (fig. 21).
Ø Remove the contents of the dust container (fig. 22).
Ø Put the filter set back into the dust container (fig. 21).
Ø Put the dust container back into the cleaner (fig. 20).
Ø Close the top cover (fig. 19).
9. Dust container open button
10. Hose
11. Telescopic tube
(PC7260, PC7270, PC7280)
12. Plastic tubes
(PC7220)
13. Dual purpose floor nozzle
14. Combination crevice nozzle / brush
(PC7260, PC7270, PC7280)
15. Upholstery nozzle
(PC7260, PC7280)
16. Cartridge filter
17. Parking position
– 3 –
– 36 –
Werbung
Inhaltsverzeichnis
