Inhaltsverzeichnis; Symbols Used In This Document - Grundfos SI 010 CNV Montage- Und Betriebsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions.
CONTENTS
1. Symbols used in this document
2. General description
2.1 Application
2.2 Nameplate
2.3 Installation kit
3. Configuration
3.1 ST5 - supply voltage
3.2 ST3 and ST4 - sensor inputs
3.3 ST1 and ST2 - signal outputs
3.4 Configuration examples
4. Installation
4.1 Mounting
4.2 Electrical connection
4.2.1 Connection of supply voltage and sensor
5. Technical data
6. Disposal
Warning
Prior to installation, read these installation and operating
instructions. Installation and operation must comply with
local regulations and accepted codes of good practice.

1. Symbols used in this document

Warning
If these safety instructions are not observed, it may result in
personal injury!
If these safety instructions are not observed, it may result in
Caution
malfunction or damage to the equipment!
Notes or instructions that make the job easier and ensure
Note
safe operation.
Page
7
8
8
8
8
9
10
10
11
12
14
14
15
16
18
19
7