Klein Tools CL800E Gebrauchsanleitung Seite 10

ENGLISH
AC/DC CURRENT (LESS THAN 600 A)
AC current is measured by pressing the clamp trigger
the clamp
3
measuring, care should be taken to ensure that the clamp is
completely closed, with the trigger
wire passes perpendicularly through the centre of the clamp
line with the arrow markings
To measure current:
1. Rotate the Function selector switch
setting.
NOTE: The meter defaults to AC measurement. Press the 'SEL'
button to toggle between AC and DC modes. The AC or DC
9
icon on the LCD indicates which mode is selected.
2. Place the clamp
align the polarity markings
the wire to avoid negative readings. The current measurement will
be shown in the display. The meter will auto-range to display the
measurement in the most appropriate range.
Disconnect test leads when measuring with the clamp.
NOTE: If non-zero values are displayed prior to measuring in DC
current mode, an offset correction is required. With the meter in DC
current mode, press and hold the 'SEL' button
current ZERO function. Subsequent DC current measurements will
automatically subtract the offset correction for improved accuracy.
10
OPERATING INSTRUCTIONS
and placing it around a wire carrying a current. When
around the wire. When measuring DC current,
3
fully released, and that the
10
.
11
to the AC/DC current A
2
on the clamp with the polarity of
15
to open
10
to activate the DC
9
3
in
3