Assembly; Assembling The Chair; Mounting The Armrest (Right) Optional Equipment - Sirona C Gebrauchsanweisung

Sirona Dental Systems GmbH
4

Assembly

4.1

Assembling the Chair:

2
4.2

Mounting the Armrest (right) Optional equipment

18 73 319 D 3292
D 3292.201.01.05.02
i
NOTE
If an armrest is required, it must be assembled first
under all circumstances (see below).
Fit the lower telescope sleeve (1) onto the base.
Insert the pneumatic spring (2) with telescope sleeves
into the chair base (cone fitting).
3
Fit the upper part of the chair onto the pneumatic spring
(cone fitting).
Snap the upper telescope sleeve (3) into place on the
upper part of the chair.
1
The armrest must be mounted on the upper part of the
chair with four screws before the upper part of the chair
is fitted onto the pneumatic spring.
Ensure that the various washers are fitted as shown and
position the four compression springs correctly!
Tighten the screws criss-cross! Use the Torx screw-
driver included in delivery.
i
NOTE
The screws can be re-used after the armrest has
been disassembled.
If the customer needs the "armrest on the left", find addi-
tional mounting steps on next page.
4 Assembly
9