Air Filter; Spark Plug; Storage; Lubrication Of Hedge Trimmer Accessory - Texas Andreas Petersen BCU52M Bedienungsanleitung

Mixing instructions:
Fig. 9
•
We recommend the ALCO 2-stroke oil in a
2.5% mixture. That means mixing 0.1 l of 2-
stroke oil with 4 l of unleaded gasoline.
•
Always follow the guidelines of mixture given
by oil manufacturer, however always use
minimum a 2.5% mixture (never 2%). If doubt
about the guideline of mixture from oil
manufacturer, then use a 4% mixture.
•
Alkylate gasoline is not recommended, as it is
2% mixture only and can damage the engine.
The warranty will not cover if this happens.
When storing the machine for more than 30 days
you should empty the tank.
Filling of gasoline - Smoking prohibited!
1. Remove the gasoline cap slowly. Place it on a
clean surface.
2. Carefully pour the oil mixed fuel into the tank.
Beware of spilling.
3. Remount the gasoline cap properly.
4. Wipe any spilled fuel.
Notice! Always turn off the engine when refueling.
Never add fuel on a running machine. Always let
the engine cool for 2 minutes before refueling.
Move more than 3 meters away from the place
where you putted fuel on the engine before it is
started.
Safety warnings
Mix and store the fuel in approved containers.
Mix the fuel outdoors where there are no
sparks or flames.
Choose a suitable place, turn off the engine
and leave it to cool for 2 minutes before
refueling.
Remove the gasoline cap slowly in order to
ease gasoline fumes pressure from the fuel
tank.
Wipe any spilled fuel. Move more than 3
meters away from the fueling site before
starting the engine.

Air filter

For correct performance and durability the air filter
must be kept clean.
1. Remove the lid of the air filter by unscrewing
the screw that fastens the lid.
2. Wash the air filter in a lukewarm soap mixture.
Leave it to dry. Pour on a little two-stroke oil
Press out any surplus oil. Replace an old and
worn filter.
3. Filter and lid is fitted again. Make sure that the
filter and lid is securely tightened.
Clean the air filter for every 5 hours or more
often if you work in dusty areas.

Spark plug

This machine is equipped with a spark with an
electrode distance of 0,6 mm. For optimal
performance it should be replaced once a year.

Storage

1. Empty all fuel from tank.
2. Clean the head, and store the machine frost
free and out of reach for children.
3. Observe all safety precautions concerning safe
storage and handling of gasoline.

Lubrication of hedge trimmer accessory

The gearbox is lubricated from the factory, but for
every 30-hour operation Grease MUST be refilled.
Top up with grease type: MULTIFAK EP-0 using a
grease gun (not included) on the lubrication nipple.
See fig. 10
Please note that the gearbox must be lubricated at
all-time (all parts)
The blades must be kept lubricated to prevent
friction and to extend the durability..

Lubricating the chain on the pruner accessory

•
Let the pruner idle for 2-3 min.
•
Place saw on a flat surface
•
Remove the lid.
•
Add chain oil in the pruner container (top up).
Depending on the conditions you should add
chain oil for every 30-45 minutes of use, so
check oil level often. If the pruner is used
without chain oil, the chain will be damaged.
16