Installation - Philips HC210 Bedienungsanleitung

XP SBC HC 210.1 SRS 07-04-2003 10:22 Pagina 6

Installation

Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK version: SBC CS030/05
12 Volt/200 mA AC/DC adapter)
1 Make sure the adapter's rated voltage
corresponds to the mains socket voltage.
2 Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
3 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter
if the transmitter is not to be used for
a long period of time.
Headphone power supply
IMPORTANT
Only use Philips SBC HB550S batteries
(R03/AAA NiMH).
1 Check if the power button of the
IR headphone is in the on position.
2 Ensure the batteries are put in the battery
compartment correctly according to the
engraved polarity symbols.
3 To recharge the headphone's rechargeable
R03/AAA NiMH batteries, first switch off
the headphone.Then connect the charge
cable between the headphone and the
transmitter (figure 3).The recharging
indicator will light up.
6
Note:
Completely empty batteries need
approximately 16 hours to recharge.
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
Headphone battery
replacement (figure 4)
IMPORTANT
Only use Philips SBC HB550S batteries
(R03/AAA NiMH).
1 Open the headphone's battery
compartment.
2 Take out the batteries and dispose of them
properly.
3 Insert new batteries. Only use Philips SBC
HB550S batteries.
4 Make sure the batteries are correctly
inserted as indicated by the engraved
symbols in the battery compartment.
5 Close the battery compartment.
IMPORTANT
Before using the IR headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.