Eberg QUBO Q40HD Bedienungsanleitung Seite 32

Note: In heating mode and dehumidifying mode, this button can not be operated
because the unit is preset to high speed in heating mode and low speed in
dehumidifying mode
7. TIMER
Programmable timer ON/OFF button
TIMER ON:: The unit switches on.
1. Press the «TIMER» button in stand-by mode to set the time you desire.
2. Once the set time has elapsed, the unit will turn on automatically.
3. If you press the POWER button before the time has elapsed, the timer setting
will be canceled and the unit will turn on.
4. You can set the mode and fan speed while setting the timer.
TIMER OFF: The unit switches off automatically after the set has elapsed.
1. Press the «TIMER» button when the unit is operating to set the time you desire.
2. Once the set time has elapsed, the unit will turn off automatically.
3. If you press the POWER button before the time has elapsed, the timer setting
will be canceled and the unit will turn off.
8. SLEEP CONTROL FUNCTION
1. In cooling mode, press SLEEP button to set the temperature. It increases by 1°C
after an hour and at increases by a maximum 2°C after 2 hours.
2. In heating mode, press SLEEP button to set the temperature. It decreases by 1°C
after an hour and decreases 2°C after 2 hours.
3. Press the SLEEP button again to cancel the setting.
9. ALARM
When the water tank is full, E4 will be displayed on the display panel. To resume
operation, please remove the rubber cap from the drainage hose to drain the
water first. The E4 warning will disappear after draining.
32